Bend-D's [Simple] Armature Kit 7.5 inch (Neon Green Color)

  • Shipping Weight: 0.268lbs
  • 1 Units in Stock


Add to Cart:
Need a strong and flexible armature to hold up your puppets for filming? Bend-D's Armature Kits are the most elaborate wire based armature kits for the best price.

Apply hot glue to glue the included 1/16" wire into place. Using hot glue allows you to pull them out later. Apply the included 5 minute epoxy (recommended) to attach the included wire into the body sections for the best animation experience!

Design update! Wrists and hands (including the simple kit) allow you to replace the wires up to three times! See photos at the bottom of this page.

Above animation by Joy Stamp

Bend-D's Armature Kits Include:

1X 3-D printed PLA plastic armature kit
1X Loctite Quick Set 5 Minute Epoxy (for every 2 kits)
1X 24 foot spool of 1/16" wire
1X 3 foot spool of 1mm wire
2X stainless steel M-4 tie downs
6X M-4 nuts
2X drilled delrin eye balls

Here are the colors of PLA filament we use...

What you need (not included):

- a 1/16" drill bit to drill any holes that are too snug for the wire
- wire snips
- needle nosed pliers
- an afternoon with some patience
- This link to the instructional video
- This link to print out the basic instructions if you lose the one included with your kit
- a rig if you want your character to jump by clicking here.

This product was added to our catalog on Friday 26 February, 2016.

Important Links

Copyright © 2024 The Clay and Stop Motion Animation Store. Powered by Zen Cart