Bend-D's Spare Hands W/Wire (Green Color)

Hands are very hard to make for stop motion puppets. These 3-D printed hands are strong, light weight, won't react with foam latex or silicone and won't fall apart!

These hands will help you focus on animation, not repairing your puppet in the middle of a shot. Three holes in the palm allow you to attach props and items to the hand by inserting some wire.

Bend-D's Spare Hands Include:

1X 3-D printed PLA plastic hands (1 left and 1 right)

1X 12 inches of 1mm aluminum wire for the fingers



What you need (not included):

- -Aluminum armature wire (1/16 inch if you want more firm fingers) (comes with human armature kit)

- M4 Stainless Tie Downs (if you want to use them or don't already have them as they are included with our armature kits)

- A 1/16" drill bit and multi-speed drill. Drill out the holes slowly and carefully only if you want the finger holes to accept this thicker 1/16" wire.

- Any common 5 minute epoxy, hot glue or crazy glue to glue the wire into the toe holes if you want to use the toe piece.