Bend-D's Tie Down Hands W/Wire (Blue Color)

If you would like to make a puppet with hands that can attach to a wall, floor or rig - these hands will do the job. Each hand has a pair of M-4 nuts for you to attach to M-4 tie downs.

Bend-D's Tie Down Hands Include:

1X 3-D printed PLA plastic hands (1 left and 1 right)

2X M-4 nuts

1X 12 inches of 1mm aluminum wire for the fingers



What you need (not included):

- -Aluminum armature wire (1/16 inch if you want more firm fingers) (comes with human armature kit)

- M4 Stainless Tie Downs (if you want to use them or don't already have them as they are included with our armature kits)

- A 1/16" drill bit and multi-speed drill. Drill out the holes slowly and carefully only if you want the finger holes to accept this thicker 1/16" wire.

- Any common 5 minute epoxy, hot glue or crazy glue to glue the wire into the toe holes if you want to use the toe piece.