What is included with the Bend-D's Human Feet?:
- 2X 3-D printed PLA plastic feet
- 4X M-4 nuts
- 1X 1 foot of 1mm aluminum Wire
- 1X 1 foot of 1/16" aluminum Wire
What you need (not included):
- M4 Stainless Tie Downs
(if you want to use them or don't already have them as they are included with our armature kits)
- A 1/16" drill bit and multi-speed drill. Drill out the holes slowly and carefully only if you want the foot to accept this thicker 1/16" wire which we recommend if you want your puppets to walk.
- Any common 5 minute epoxy
, hot glue or crazy glue to glue the wire into the toe holes if you want to use the toe piece.
This product was added to our catalog on Monday 23 May, 2016.